Defender Plate Carrier- OCP Scorpion

  • Fits L-XXL
  • Accomodates 10x12, Medium and Large ESAPI plates front and back
  • Accepts side plates 6x6" or 6x8" with built-in pockets.
  • Emergency drag handle
  • Accepts BALCS/SPEAR armor* Condor-specific
  • Release buckles on shoulders and waist strap
  • Can be worn with or without cummberbund
  • Water Resistant
  • 1000D Polyester (Solid colors) -Fabric is foreign
  • 1000D Nylon (Camo colors) -Fabric is made in USA and is licensed
  • Shoulder pads have loops for equipment and/or hydration tube
  • Sewn in China
  • NTOA Recommended
Backorder
SKU
DFPC-800
$134.99
 

This carrier is adjustable to fit within following ranges for both Men & Women

Measurements Height 6'+" Chest 42-44" Chest 46-48" Chest 50-52"
         
 

      Infidel Body Armor 10x12 Defender Plate CarrierComposite Level IV

The Defender Plate Carrier is designed with heavy webbing on all sides for any MOLLE compatible gear and accessories. The DFPC also features an internal cummberbund and padded shoulders support and comfort. 

The DFPC will allow you to use both BALCS Inserts (level II or level IIIa) and/or Rifle Plates (level III or IV).

The inserts cover a much larger area inside the plate carrier, are flexible, and provide additional protection against trauma and pistol rounds that don't hit the plate.  You can wear the DFPC with just the plates or just the inserts, or you can wear both the inserts and the plates for maximum protection.

Choose Level IIIa, Level III, or both!

Pistol Level IIIa Stops: .44 Magnum, 9mm FMJ, 7.62x25, 5.7x28, .50AE and other specialty pistol rounds and provide up to 40% blunt trauma reduction when worn in conjunction with a rifle plate.  Knife resistant to both stabs and slices. Besides being light, these inserts are soft and comfortable and just over 1/4" thick. They are made of Kevlar KM2 and Goldflex II for really good stopping power for fragments and point blank shots and are thinner and lighter than standard Kevlar. 

Rifle Level III AR550 Stops:  5.56 (M855, M193); 7.62x39 (Ball), 7.62x54R (LPS), 7.62x51 (Ball); 30-06 (JHP, FMJ); .357 mag; .45 cal; 50 cal Beowulf; 9mm; 12 Gauge Shotgun slugs, and more.  All of these rounds were fired from semi-auto AR-15s, AK-47s, MAK-90s, bolt action Rifles, Glocks, Revolvers, and pump shotguns. This is a level III+ plate as tested by a certified NIJ Laboratory. Complies with MIL-46100 Rev E. for class 1 armor and passed the test against a 30 Caliber Armor Piercing bullet at 2426 fps as tested at the US Army Aberdeen Test Center.  Weight for 10x12 single curve with 1/4" polyurea anti-frag coating is 9lbs.

Rifle Side plates are available in Level III AR550.

 
 
 
More Information
Armor TypePistol
Write Your Own Review
You're reviewing:Defender Plate Carrier- OCP Scorpion
Your Rating